Student-Contributed Wiki
An awesome team of students from our education program made this wiki.
This guide addresses common problems and solutions for the Hoover Power Path Pro Advanced.
Lift and remove tough stains like a Pro with the Power Path Pro XL Carpet Cleaner. Our patented SpinScrub® Brush Technology and Heat Activated drying will get you back on your floors in no time. The Power Path® Pro Advanced Carpet Cleaner combines two powerful scrubbing systems to bring you a whole new level of deep clean. Featuring a rotating brushroll and our patented SpinScrub® Technology, you'll lift and remove tough, stubborn stains. Hoover FH51101 Power Path Pro XL Carpet Cleaner Parts and Accessories. Largest Selection, Best Prices, Free Shipping Available at VacPartsWarehouse.com.
Cleaner won't turn on
Power Path Pro will not run when the power switch is turned on.
Power cord not firmly plugged into outlet
Plug the unit in firmly into the power cord. If the cleaner is still unresponsive, try using a new outlet.
Blown fuse or tripped breaker
Check the fuse or breakers in your home. Use this guide to replace/reset the breaker in your home.
Faulty power switch
If the outlets in your home are functioning properly, use this guide to replace the power switch on the cleaner.
Cleaner needs service
If all options are exhausted, take the cleaner to a service center. To find the nearest location, visit the Hoover website or call 1-800-944-9200.
Cleaner won't pick up or suction is low
Cleaner will pick up little to no dirt or water from the floor.
Dirty water tank is full, clogged, or not properly installed
If the dirty water tank is full, a yellow float will rise to the top of the dirty water tank and automatically decrease the amount of suction in the cleaner. This will cause the noise on the motor to be noticeably higher-pitched. Visit page 8 of the Hoover owner's manual to view how to properly install, empty, and clean the dirty water tank.
Air path is clogged
Suction on the cleaner can be stopped or reduced due to a clogged air path. Use this guide to remove the hose from the cleaner and unclog the air path if it is not clear.
Water escaping from cleaner
Water escapes from the dirty water tank or clean water solution tank and spills onto the floor.
Dirty water wank is full or not properly installed
Water can overflow from the dirty water tank if the cleaner if functioning when full or not properly installed. Visit page 8 of the Hoover owner's manual to view how to properly install, empty, and clean the dirty water tank.
Clean water solution tank is not installed properly
Water can overflow from the clean water solution Tank if it is not properly installed. Visit page 7 of the Hoover owner's manual to view how to properly fill and install the clean water solution tank.
Cleaner won't dispense
Cleaner will not dispense clean water onto the floor.
Clean water solution tank not installed properly
Water will not dispense if the clean water solution tank is not properly installed. Visit page 7 of the Hoover owner's manual to view how to properly fill and install the clean water solution tank.
Cleaner needs service
If the solution above does not solve the issue, take the cleaner to a service center. To find the nearest location, visit the Hoover website or call 1-800-944-9200.
Hose nozzle will not spray after filling the clean water tank or detergent container
No water is released from the hose nozzle when the Clean Water Tank or Detergent Container is full.
The connection to the tool port is loose
Verify that the hose is properly connected to the hose connection.
Air is trapped in the pump and hose
If the hose does not spray when the cleaner is turned on, lower the hose down to the floor and hold the trigger for up to 1 minute.
Faulty hose
If the two solutions above do not work, there could be a puncture on the hose that prevents proper function. A new hose will need to be bought. Use this guide to remove and replace the faulty hose.
Motor noise becomes high-pitched
The motor is emitting a high-pitched sound that was not present before.
The float in the Dirty Water Tank has been activated
If the dirty water tank is full, a yellow float will rise to the top of the dirty water tank and automatically decrease the amount of suction in the cleaner. This will put stress on the suction motor and cause the high-pitched noise. Visit page 8 of the Hoover owner's manual to view how to properly install, empty, and clean the dirty water tank.
Air path is clogged
A clogged air path can put stress on the suction motor, causing the high-pitched noise. To check the air path, use this guide to remove the hose from the cleaner and unclog the air path if it is not clear.
Faulty suction motor
If the dirty water tank is empty and the air path is clear then the suction motor needs to be replaced. Use this guide to remove and replace the suction motor.
Brush rolls are not spinning
The brush rolls will not spin when the cleaner is turned on.
Something is jammed in the brush roll
Large objects can get stuck on the nozzle of the cleaner. This causes a jam in the brush rolls. Use this guide to remove the brush rolls and get rid of any debris.
Belt needs to be changed
If the brush rolls are not jammed then the belt on the cleaner needs to be replaced. Use this guide to remove and replace the belt.
hoover carpet cleaner,FH 50150, just stopped in the middle of cleaning. waited and waited, still won't start. Purchased new power switch fuse. Still will not work. Of course it's off of warranty by a few months. What can I do now, besides screaming!
Is this a good question?
Comments:
It was off warranty, I only had it a little over a year, but decided to just give Kohl's a call. No questions asked, I was able to take it back for full refund or replacement. I went for replacement. I would have certainly used your ideas! Thanks for the inputs!
lucky you, i purchased a hoover power scrub elite 7 months ago online from hsn they wont help me i contacted hoover but havnt heard anything from them so dissapointed only used it once the brushes quit working and wont suck and yes i know about putting the dirty water tank in correctly, the only thing the dumb thing will to now is blow its heat. im so disscusted
Hoover Power Path Pro Xl Carpet Cleaner Manual
the thing to turn it on wont start the machine, it just quit
Hoover Power Path Pro Advanced Manual
Mine just stopped turning on too! Seems to be a common problem with this model. Also the leaking of water and sporadic working altogether. Company should offer compensation!!!