Download Acura Integra Header Installation Instructions Parts List: 1 – Stainless Steel Header 1 – Oxygen Sensor Plug (for cars with oxygen sensor in catalytic converter) • Remove existing exhaust manifold and “A” pipe: Remove manifold, “A” pipe, and heat shields per factory service manual removal procedures. • Loosen bracket: Loosen the bracket indicated in the diagram to the right. This will allow easier alignment of the header to this bracket. • Install oxygen sensor: Install oxygen sensor into bung on collec- tor. Note: Some cars will have the oxygen sensor in the catalytic converter. In this case, install the supplied plug into the fitting on the header collector. • Install Comptech Header: Install header from bottom of car, line up all connections, and start all nut and bolt fasteners before final tightening to factory specifications. (torque header to cylinder head bolts/nuts to 23 lbs/ft) see diagram at right for other torque specs. • Wipe down header: Use a good solvent to remove any oil or contaminants on the header before starting engine. This will insure even discoloration (typical of stainless steel) of the header as it heats up. • Start engine: Start the engine and check for any exhaust leaks. After a few days of driving the car, recheck all con- nections for tightness.
2012 2013 Rolls Royce Phantom Owners Manual Operators User Guide Book V12 6.8l. $5 Porsche 911s Factory Owner's Owner User Manual Guide Book W Case. $5 Kenworth T800 Semi Truck Original Owner Owner's User Guide Manual Book Set.
Ford 6.8 V10 Performance Upgrades
Ford V10 6.8l Remanufactured Engine
Download Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and can be ignited, resulting in possible personal injury. WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. 1. Disconnect the battery ground cable. 2. Drain the coolant system. 3. Compress and slide the hose clamp and disconnect the water outlet hose. 4. Remove theair cleaner outlet tube. 5. Remove the 6. Disconnect the accelerator and speed control cables and the return spring. 7. Position the accelerator cable bracket aside. Remove the bolts. Position the bracket and cables aside. 8. Disconnect the vacuum lines: PCV. brake booster. engine sensor control wiring harness. 9. Remove the bolt (RH) and position the capacitor aside. 10. Disconnect the vacuum line. 11. Disconnect the five RH fuel injector electrical connectors and five ignition coil electrical connectors. 12. Disconnect the idle air control motor electrical connector and the bypass hose. 13. Disconnect theheater hose. 14. Disconnect the EGR transducer and the throttle position sensor connectors. 15. Disconnect the EGR transducer vacuum lines. 16. Remove the EGR transducer bracket. 17. Position the EGR valve to exhaust manifold tube aside. Disconnect the upper fitting.